The correct installation method of the dust bag (1) method of installing the external filter bag Mouthpiece the mouth of the bag and the perforated plate are reliably sealed and fixed. 2) the filter bag is suspended vertically under the perforated plate. 3. Adjacent filter bags do not collide with each other. Bagla filter bag […]…

(1) connection ring type: fasten the horizontal rings of the two skeletons in the semicircular grooves of the connection ring. The connection ring type is a relatively stable connection method, but its processing procedures are relatively cumbersome, the cost is high, but the strength and verticality are better. Currently, many large filter bag dust removal […]…

The filter bag is the key element that determines the dust removal efficiency and working temperature of the bag filter. The cost of replacing the filter bag is also the primary maintenance cost of the filter bag. Therefore, the life of the filter bag is related to the operating conditions and cost of the dust […]…

The support ring and longitudinal bars are evenly distributed and should have satisfactory strength and rigidity, be able to withstand the gas pressure of the filter bag during filtration and cleaning, and avoid collisions and impacts during normal transport and installation. The resulting damage and deformation. The welding points of the dust collector structure must […]…

The dust collector frame is also called the dust collector bag cage, also known as the dust collector frame. The frame of the dust collector is the rib of the filter bag. It should be light and easy to install and maintain. The quality of the frame directly affects the filtration status and service life […]…

The airflow of the dust collector structure is a complex turbulent state composed of tangential, radial, and axial directions. Between them, the tangential velocity is the same in the internal and external whirlpool flow, and outward, and their sizes are different. The tangential velocity decreases with the decrease of the cylinder’s radius in the internal […]…

Poor source of pulse gas (1) air supply low-pressure air. If the application of the pulse valve task cannot be satisfied, the dust cannot be cleaned normally, which causes the dust collector to “pocket “. (2) wind pressure at low pressure. At the time of cleaning the filter bag, as long as the pressure inside […]…

Dust filter bag (1) the data from the dust filter bag do not match the characteristics of the dust, forming a partial stoma infarction. For powder with high concentration, small particle size, high humidity, and high viscosity, membrane-coated filter bags should be used. (2) the gas containing dust is too high and the system does […]…

Filter bag is damaged When the bag filter is working normally, wear of dust on the surface of the filter bag will cause “needle” holes in the bag after a long period of use. Sometimes during the cleaning process, under the impact of wind speed at low pressure and high airflow, the bag will also […]…

Sometimes the strength of the dust collector bag increases beyond the normal value, and the strength cannot be reduced even after the cleaning operation. What should be done? Allow me to talk about the reasons and solutions for increasing the strength of the dust collector bag. Why? 1. The phenomenon of the bag of pasta […]…